HP Kayak XU series 03xx
Showing all 23 results
-
Fastraid 2 (Adaptec ARO-1130B) PCI RAIDport Adapter Board kit – Includes adapter board, 16MB SIMM memory, and software – Plugs into special extended PCI slot on system processor board of Kayak XU and XW – FastRAID 2 (Adaptec ARO-1130B) PCI RAIDport Adapte
-
32MB, 100MHz, 72-bit, unbuffered ECC SDRAM DIMM memory module – (D6521A)
$76.55 -
HP Kayak XAs instruction guide for replacing the: cover, expansion card, LCD front panel, hard drive fan, and minitower multimedia panel – (English, French, German, Spanish, and Italian)
-
Ribbon cable – Has 14-pin (F) connectors – 15.9cm (6.3in) long – From combination LAN/Ultra Wide SCSI board (without internal 50-pin connector) to system board
-
SCSI ribbon cable with termination – A 68-pin (M) connector marked `Motherboard end` and five 68-pin (M) connectors for drives – 49.5cm (19.5in) long
-
SCSI ribbon cable with termination – 50-pin (F) connector for SCSI controller and two 50-pin (F) connectors for drives – 63cm (25in) long – May require 50-Pin to 68-Pin SCSI adapter
-
Chassis assembly – Includes the chassis, multimedia control panel, fan/speaker assembly, airflow guides, cover lock, and hard drive fan – Does NOT include the exterior cover assembly
-
Processor fan/airflow guide – Includes fan with cable and airflow guide – Mounts to upper rear of chassis
$60.00 -
Multimedia panel plastic bezel – Multimedia panel plastic bezel – Mounts on the front panel (below the drive bay slots)
-
Drivers and documentation CD-ROM – Kayak XU series 03xx
-
Narrow to Wide SCSI adapter – Allows connection of an 8-bit, 50-pin Narrow SCSI cable to a 16-bit, 68-pin Wide SCSI controller (Adapter is 68-pin male to 50-pin male)
-
18.0GB Ultra160 Wide SCSI LVD hard drive – 10000 RPM, 3.5in form factor, 1.0in high – SCAM level 3 compliant
$72.29 -
IDE DVD-ROM drive kit – 5X DVD-ROM read, 32X CD-ROM read – Kit inlcudes two IDE cables, audio cable, mounting rails, CD-ROM with software, and user’s manual
-
256MB, 100MHz, 72-bit, unbuffered ECC SDRAM DIMM memory module
$69.51 -
4MB WRAM video memory module – For Matrox Millennium II AGP graphics board – (D5487A)
-
Side mounting rail kit – For mounting 5.25in wide media accessible drives into the chassis – Kit includes three pairs of rails, six screws (for securing the front of the rails to the chassis), and instructions
-
5.25-inch filler panel (Flint Gray, plastic) – For use in covering empty 5.25-inch drive slots
-
Side mounting rail kit – For mounting 5.25in wide media accessible drives into the chassis – Kit includes three pairs of rails, six screws (for securing the front of the rails to the chassis), and instructions
-
5.25-inch filler panel (Flint Gray, plastic) – For use in covering empty 5.25-inch drive slots
-
Intel Pentium II processor – 400MHz (Deschutes, 100MHz front side bus, 512KB Level-2 cache, Slot 1) – Includes heat sink
$55.00 -
4.5GB Ultra Wide SCSI hard drive – 10,000 RPM, 3.5-inch form factor, 1.0-inch high (Seagate Cheetah, model ST34501W)
$79.00 -
9.1GB Ultra2 Wide SCSI hard drive – 10,000 RPM, 3.5-inch form factor, 1.0-inch high (Seagate Cheetah, model ST39102LW)
$77.00 -
18.0GB Ultra160 Wide SCSI LVD hard drive – 10,000 RPM, 3.5-inch form factor, 1.0-inch high – SCAM level 3 compliant
$77.00